返回信息流1.内核启动出现找不到eth0的
[ 12.877226] xemacps e000b000.ps7-ethernet: eth0: no PHY found
[ 12.877226] xemacps e000b000.ps7-ethernet: XEMACPS mii bus mii_probe fail.
[ 12.877228] IP-Config: Failed to open eth0
[ 12.877229] IP-Config: Device `eth0' not found
zynq> ifconfig eth0 up
[ 528.273417] xemacps e000b000.ps7-ethernet: eth0: no PHY found
[ 528.273418] xemacps e000b000.ps7-ethernet: XEMACPS mii bus mii_probe fail.
ifconfig: SIOCSIFFLAGS: No such device or address
2根文件系统挂载失败
fdisk -l
Device Boot Start End Blocks Id System
/dev/mmcblk0p1 129 64128 2048000 b Win95 FAT32
Partition 1 does not end on cylinder boundary
/dev/mmcblk0p2 64129 121472 1835008 83 Linux
Partition 2 does not end on cylinder boundary
zynq> mount /dev/mmcblk0p1 /mnt
mount: mounting /dev/mmcblk0p1 on /mnt failed: Device or resource busy
这是一条镜像帖。来源：北邮人论坛 / embedded-system / #14862同步于 2014/7/9
Embedded_System机器人发帖
《！！求助——谢谢》关于xilinx zynq-7000的linux启动！！！
vincechu
2014/7/9镜像同步0 回复
订阅后，新回复会通过你的通知中心匿名送达。
0 条回复
暂无回复 · 你可以订阅本帖等待新回复。