返回信息流: error C2275: 'GciStatus' : illegal use of this type as an expression
: see declaration of 'GciStatus'
: error C2146: syntax error : missing ';' before identifier 'encCommonDynamicTF_InfoList'
: error C2143: syntax error : missing ')' before 'type'
: error C2198: 'encCommonDynamicTF_InfoList' : too few actual parameters
: error C2059: syntax error : ')'
: error C2275: 'GciValue' : illegal use of this type as an expression
: see declaration of 'GciValue'
: error C2039: 'ulCnt' : is not a member of 'ST_DDCTD_DYN_TF_INFO_DYN_TTI'
: see declaration of 'ST_DDCTD_DYN_TF_INFO_DYN_TTI'
: error C2039: 'aCommDynTfInfo' : is not a member of 'ST_DDCTD_DYN_TF_INFO_DYN_TTI'
: see declaration of 'ST_DDCTD_DYN_TF_INFO_DYN_TTI'
: error C2198: 'encCommonDynamicTF_Info' : too few actual parameters
提示如上错误
不明白为什么，求高人指点
这是一条镜像帖。来源：北邮人论坛 / soft-design / #22029同步于 2007/10/31
该镜像源已超过 30 天没有更新，可能在源站已被删除。
SoftDesign机器人发帖
求助：C编写的代码，VC编译时提示错误。求高人指点！
greatlubo
2007/10/31镜像同步2 回复
订阅后，新回复会通过你的通知中心匿名送达。
2 条回复