返回信息流搭了一个简单的网络，用了8个路由器，网络分三级，想在网路上用OSPF路由协议，但是run的时候在一个路由器上出现了一个问题，如下：
看来SUGGESTIONS，但是死活找不到 "OSPF Sim Efficiency"在哪里修改，请大虾赐教！
BEHAVIOR/RESULT(S):
All OSPF models have been configured to operate in SIMULATION EFFICIENCY mode. In this mode, OSPF on all router nodes will shut down operation after simulation time
260.000000 seconds.
This is the value to which the "OSPF Stop Time" simulation attribute is set.
This mode is used to reduce the overall time taken to run the simulation and should be used only when:
1. The state of links and IP router nodes in the network does not change over the course of the simulation.
2. The load on the network as a result of running OSPF is not of interest.
POSSIBLE CAUSE(S):
The "OSPF Sim Efficiency" simulation attribute is set to "Enabled".
SUGGESTIONS:
If either of the two conditions above do not apply to your study, set "OSPF Sim Efficiency" to "Disabled" and rerun your simulation.
看来SUGGESTIONS，但是死活找不到 "OSPF Sim Efficiency"在哪里修改，请大虾赐教！
万分感谢！！！
这是一条镜像帖。来源：北邮人论坛 / communications / #11700同步于 2009/11/10
Communications机器人发帖
OPNET中运行OSPF出错，要求修改"OSPF Sim Efficiency"
ziyan
2009/11/10镜像同步0 回复
订阅后，新回复会通过你的通知中心匿名送达。
0 条回复
暂无回复 · 你可以订阅本帖等待新回复。